Extron electronic Extron Electronics Switch SM 26 Bedienungsanleitung PDF herunterladen

Product Category

SM 26 • Setup Guide

NOTE: Unless otherwise stated, mounting hardware is not included.

This setup guide contains installation information about the Extron SpeedMount

SM 26 speaker.

NOTE: Installation and service must be performed by authorized personnel only.

Installing the Speaker Mounting Plate

The SM 26 speaker comes with a at mounting plate and an adapter for positioning the speaker 10° up, down, left, or right.

• 0° mounting plate — The flat (0°) mounting plate allows the speaker to be mounted flat on a suitable surface.

• 10° mounting adapter — The 10° mounting adapter allows the speaker to be installed at a 10 degree angle so that the

speaker can be pointed up, down, left, or right from an elevated position by rotating the adapter.

The mounting plate can be installed vertically or

horizontally as shown below right.

NOTES:

• Observe all applicable building codes and local ordinances when installing the speaker.

• If mounting the SM 26 with the yoke mount, see the Yoke Mount Setup Guide.

Mounting to a Wall Stud

1. Locate the wall stud where the mounting plate will be installed.

2. If using the 10° mounting adapter, position the adapter over the wall stud according to how the speaker will be angled and

mark the positions of the pilot holes. See the figure below right for mounting hole locations.

If not using the adapter, position the mounting plate against the wall. The #26 arrow molded into the mounting plate indicates

the vertical midpoint of the SM 26 speaker when it is mounted on a wall stud. While positioning the mounting plate on the

wall, mark the location of two pilot holes using the holes indicated below.

Horizontal Mounting

Catch Tab

Vertical Mounting

Mounting

Holes

33-0000-01 Rev. Ax1

–

LOOP

–

LOOP

SM26 Speaker

Stud

Mounting

Holes

0° Mounting Plate

10° Mounting Adapter

1 2 3 4

Inhaltsverzeichnis

Seite 1 - SM 26 • Setup Guide

1Product CategorySM 26 • Setup GuideNOTE: Unless otherwise stated, mounting hardware is not included.This setup guide contains installation informati

Seite 2 - 0° Mounting Plate

2SM 26 • Setup Guide (Continued) NOTE: A speaker wire access hole (see the following figures) must also be cut in the wall. Mark that hole location

Seite 3 - Catch Tab

3Product Category NOTE: If surface mounting, route the wires through alternate access points as shown at right. ATTENTION: Use the appr

Seite 4 - 68-2164-50

468-2164-50 Rev. B09 13Extron Headquarters+1.800.633.9876 (Inside USA/Canada Only)Extron USA - West Extron USA - East +1.714.491.1500 +1.919.863.179

Kommentare zu diesen Handbüchern

Keine Kommentare

Extron electronic Extron Electronics Switch SM 26 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Elektrische Verlängerungskabel Extron electronic Extron Electronics Switch SM 26 herunter. Extron electronic Extron Electronics Switch SM 26 User's Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern